Easy Cleaning Programme; Cleaning Milk System Programme; Cleaning Coffee System Programme; Descaling Programme - melitta LatteSelect Manual De Instrucciones

Care and maintenance
8.5 Easy Cleaning programme
After a beverage has been prepared with
milk, the appliance will ask you to start the
Easy cleaning programme to rinse the milk
system.
You can also access the programme at any
time by navigating to Care > Easy cleaning
in the menu.
8.6 Cleaning milk system
programme
The Cleaning milk system programme is not
only used to rinse the milk system, but also
to clean it. You should run the programme
each week if you prepare beverages with
milk.
Only use Melitta® Perfect Clean milk
system cleaning agent for automatic
coffeemakers. Observe the instructions on
the packaging of the milk system cleaning
agent.
Use the coffee grounds container as a
collecting container. The programme takes
approximately 3 minutes and should not
be interrupted.
You can access the programme by navigat-
ing to Care > Cleaning milk system in the
menu.
8.7 Cleaning coffee system
programme
The Cleaning coffee system programme
is used to remove residues and coffee oil
residues. You should run the programme
every two months or when the appliance
asks you to do so. Beforehand, you should,
however, clean the brewing unit and the
surfaces inside the appliance (see sec-
tion 8.2, page 25).
Only use Melitta® Perfect Clean cleaning
tabs for automatic coffeemakers. Observe
the instructions on the packaging of the
cleaning tabs.
Caution! Cleaning agent causes eye
irritation. If it accidentally comes into
contact with your eyes, you should
rinse them with clear water for several
26
minutes. Consult a doctor if symptoms
persist.
Use the coffee grounds container as a
collecting container. The programme takes
approximately 15 minutes and should not
be interrupted.
You can access the programme by navigat-
ing to Care > Cleaning coffee system in the
menu.

8.8 Descaling programme

The Descaling programme removes
limescale deposits. You should run the
programme every three months or when
the appliance asks you to do so.
There must not be a water filter in the
water tank during descaling. If you use a
water filter, you need to remove it before
descaling (see section 8.10, page 27).
Only use Melitta® Anti Calc liquid descaling
agent for automatic coffeemakers. Observe
the instructions on the packaging of the
descaling agent.
Caution! Descaling agent causes eye
irritation. If it accidentally comes into
contact with your eyes, you should
rinse them with clear water for several
minutes. Consult a doctor if symptoms
persist.
Use the coffee grounds container as a
collecting container. The programme takes
approximately 25 minutes and should not
be interrupted.
You can access the programme by navigat-
ing to Care > Descaling in the menu.
Thoroughly rinse out the water tank and fill
it with fresh tap water after descaling.

8.9 Setting the water hardness

The hardness of the tap water influences
how often you have to descale the appli-
ance. The harder the tap water, the more
frequently you have to run the Descaling
programme.
Determine the water hardness with the
enclosed test strip. Observe the instruc-
tions on the test strip and the information
in the following table.