Integrated Descaling Programme - melitta CaffeO SOLO Manual De Instrucciones

Note
If the symbol lights up during the cleaning process, it means that there is
air in the lines inside the appliance.
– Should this happen, fill the water tank and press the button for coffee
strength.
The pump inside the appliance is activated. After it has been successfully
vented, the appliance is ready for operation.
9.4

Integrated descaling programme

The integrated descaling programme removes limescale in the interior of the
appliance. It takes a total of approximately 30 minutes. The symbol for descaling
flashes during the entire process.
Prerequisite: The appliance must be switched off (see „Switching on and off"
on page 49).
Caution!
– Carry out the integrated descaling programme every 3 months or when the
descaling symbol
– Only use Melitta
®
descaling products are specifically designed for the Melitta
SOLO .
®
– Never use vinegar or other descaling agents.
Run the integrated descaling programme as follows:
1 Before descaling, remove – if used – the Melitta
from the water tank (see page 50).
2 Simultaneously press both the button for two-cup dispensing
the ON/OFF button
→ The symbol for descaling
The drip tray symbol
illuminates on the display.
ANTI CALC Espresso Machine descaling agent. These
for about 3 seconds.
flashes.
illuminates.
CAFFEO
® ®
Claris water filter
® ®
and
65 65