Integrated Descaling Programme - melitta CAFFEO SOLO Manual De Instrucciones

Cleaning phase 2 (
When illuminates, proceed as follows:
• Fill the water reservoir with tap water up
to the max. mark.
• Press outlet 2 all the way down.
• Press the button to continue with
the cleaning programme (takes about 5
minutes).
Cleaning phase 3 (
When illuminates, proceed as follows:
• Empty the drip tray and coffee grounds
container.
• Insert the drip tray without the coffee
grounds container
• Place the coffee grounds container
under outlet 2.
Cleaning phase 4 (
bean is flashing):
• The cleaning programme will be
continued again and takes about 5
minutes.
When illuminates, proceed as follows:
• Empty the drip tray and coffee grounds
container and insert them in the
appliance as usual.
The cleaning programme is finished.
):
):
, the middle

Integrated descaling programme

Warning!
The descaling agent can cause skin
irritations
Comply with the safety instructions
and the dosing information specified
on the descaling agent packaging.
The integrated descaling programme
(takes about 30 minutes) removes lime
residues inside the appliance. The symbol
for descaling flashes during the entire
process.
The descaling programme should be
performed every 3 months, however, at
the latest when illuminates („Setting
the water hardness", Seite 19).
Only use Melitta ANTI CALC.
®
• Switch off the appliance.
• Remove the water filter if necessary
(„Water hardness and filter", Seite 18).
• Press the and
simultaneously for approx. 3 seconds.
flashes, illuminates.
• Empty and insert the drip tray.
illuminates.
• Completely empty the water reservoir.
• Add the descaling agent to the water
reservoir according to the instructions on
the packaging.
• Insert the water reservoir.
• Press the button to start the
descaling programme (takes about 15
minutes).
buttons
21