Resetting The Microprocessor; About This Manual; Use And Care Of The Remote Control; Installing The Battery - Pioneer AVH-X5750BT Manual De Instrucciones

Precaution
Data subject to erasure
The information is erased by disconnecting the yellow lead from
the battery (or removing the battery itself).
Some of the settings and recorded contents will not be reset.
●

Resetting the microprocessor

CAUTION
Pressing the RESET button resets settings and recorded
contents to the factory settings.
Do not perform this operation when a device is connected
●
to this product.
Some of the settings and recorded contents will not be
●
reset.
The microprocessor must be reset under the following
conditions:
Prior to using this product for the first time after installation.
●
If this product fails to operate properly.
●
If there appears to be problems with the operation of the
●
system.
If your vehicle position is shown on the map with a signifi-
●
cant positioning error.
1 Turn the ignition switch OFF.
2 Press the RESET button with a pen tip or other
pointed implement.
Checking part names and functions on page 7
Settings and recorded contents are reset to the factory settings.

About this manual

This manual uses diagrams of actual screens to describe opera-
tions. However, the screens on some units may not match those
shown in this manual depending on the model used.
Meanings of Symbols Used in This
Manual
This indicates model name that are supported
X5750BT
the described operations.
This indicates to touch an appropriate soft key
on the touch screen.
This indicates to touch and hold an appropriate
HOLD soft key on the touch screen.
6
< CRD4824-A >
6
This indicates that there is a reference or
supplementary for the key or screen.
Use and care of the remote
control

Installing the battery

Slide the tray on the back of the remote control out and insert the
battery with the plus (+) and minus (–) poles aligned properly.
When using for the first time, pull out the film protruding
●
from the tray.
WARNING
Keep the battery out of the reach of children. Should the
●
battery be swallowed, consult a doctor immediately.
Batteries (battery pack or batteries installed) must not be
●
exposed to excessive heat such as sunshine, fire or the
like.
CAUTION
Remove the battery if the remote control is not used for a
●
month or longer.
There is a danger of explosion if the battery is incorrectly
●
replaced. Replace only with the same or equivalent type.
Do not handle the battery with metallic tools.
●
Do not store the battery with metallic objects.
●
If the battery leaks, wipe the remote control completely
●
clean and install a new battery.
When disposing of used batteries, comply with
●
governmental regulations or environmental public
institutions' rules that apply in your country/area.
"Perchlorate Material – special handling may apply.See
●
www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable
to California, U.S.A.)"

Using the remote control

Point the remote control in the direction of the front panel to
operate.
The remote control may not function properly in direct
●
sunlight.
Important
Do not store the remote control in high temperatures or
●
direct sunlight.
Do not let the remote control fall onto the floor, where it
●
may become jammed under the brake or accelerator pedal.