Removing The Display Unit; Resetting The Microprocessor - Pioneer AVD-W7900 El Manual Del Propietario

Before You Start
3 Connect the cable to the display unit.

Removing the display unit

To deter theft of the display unit, remove the
display unit when leaving the vehicle.
1 Hold down the release section and un-
plug the connector.
2 Unlock the lock release lever, then slide
the display unit and detach it from the
base.

Resetting the microprocessor

You can reset the microprocessor to its initial
settings.
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Press SOURCE/POWER and hold until
the unit turns off.
2 Hold down SOURCE/POWER and d
simultaneously.
Autogood products «130»
Base
Lock release lever
Mounting arm
(sold separately)
Section
02
7
En