Description - Hilti PD 40 Manual De Instrucciones

Symbols
Read the Return waste
operating material for
instructions recycling.
en
before use.
Laser class 2 Do not look
according to into the
EN 60825- beam.
3:2007
Battery status Hardware
indicator

2 Description

2.1 Use of the product as directed
The tool is designed for measuring distances, calculating areas and adding or subtracting distances.
Do not use the tool as a leveling tool.
Measurements taken from plastic foam materials such as polystyrene foam, from snow or from highly reflective
surfaces (mirrors, glass, etc.) may produce inaccurate results.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
Take the influences of the surrounding area into account. Do not use the appliance where there is a risk of fire or
explosion.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and additional equipment.
Modification of the tool is not permissible.
NOTE
Observe the permissible operating and storage temperatures.
2.2 Display
The measurements, settings and tool status are shown in the display. When the tool is in measuring mode, the
measurements taken are shown at the bottom of the display area (the result line). When using a function, e.g. area
measurement, the distances measured are shown in the intermediate result line and the calculated result is shown at
the bottom of the display (the result line).
16
Laser class II
according to
CFR 21, § 1040
(FDA)
>1/4s
Temperature
indicator
Unfavorable
errors operating
conditions
Type identification plate
PD 40
Hilti = trademark of Hilti Corp., Schaan, LI Made in Germany
Serial number
AVOID EXPOSURE
Laser radiation is emitted from this aperture
LASER RADIATION - DO NOT
STARE INTO BEAM
620-690nm/0.95mW max.
CLASS II LASER PRODUCT
DIN EN 60825-1:2007
This device complies with part 15 of
the FCC Rules. (1) This device may not
cause harmful interference, and (2) this
device must accept any inter-
ference received, including inter-
ference that may cause undesired operation.
Item No.: 30399 Power: 3V nom/400 mA
Manufactured:
PD 40
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
01