Use
(4)
The Backpacker can be removed by first taking the harness off the user, pressing the spring loaded
arms on the nozzle, and sliding the D-ring past the arms.
Fig. 5
3.2.4
Workman Twin Leg PFL
Installation
US
12
Connect the snaphook to a suitable anchorage connector. If the anchorage connector is out of
reach, then use MSA's Remote Connect/Disconnect System.
Insert
Fig. 6
Connect
(1)
Insert the back D-ring of the harness into the D-ring
connector located on the PFL.
(2)
Ensure the D-ring is correctly installed by pulling back on
the D-ring.
Both tabs of the PFL should be closed preventing the
D-ring from exiting the unit.
(3)
Orient the PFL on the harness with the D-ring at the
bottom of the unit and the lanyard legs exiting the top of
the unit.
(4)
Connect the securing straps to the upper torso straps of
the harness.
Self-Retracting Lanyard
Fig. 7
Disconnect