Emission Levels - Festool PRECISIO Serie Manual De Instrucciones

- The cutting width of the saw blade must be
larger and the standard blade thickness nar-
rower than the thickness of the spacer wedge
(2.2 mm).
- The tool must be suitable for the material to
be processed.
- Deformed or cracked saw blades and saw
blades with blunt or broken cutting edges
must not be used.
- Transport and store the tools in a suitable re-
ceptacle;
- Only use the machine if all safety devices are
in their correct positions, the machine is in
good condition and has been well maintained.
- Replace a worn or damaged (e.g. bedded in)
tabletop immediately.
- Operating personnel must have received ade-
quate training in the use, set-up and operation
of the machine.
- Faults on the machine, including the separat-
ing guards or the tool, must be reported to
maintenance staff immediately upon discov-
ery. The machine must not be used until the
fault has been eliminated.
- Wear suitable personal protec-
tive equipment: ear protection
to reduce the risk of hearing
loss, safety goggles, a dust
mask to prevent inhalation of
harmful dust, protective gloves
when working with raw materials and when
changing tools.
- To minimise noise, the tool must be sharpened
and all noise reducing elements (covers etc.)
must be properly adjusted.
- When cutting wood, connect the machine to a
dust extractor corresponding to EN 60335-2-
69, dust category M.
- Never process material containing asbestos.
- Make sure that there is adequate lighting in
the room or workplace.
- Always assume the correct position before
starting work:
- front at the operating end,
- facing the machine,
- next to the cutting line.
- Use the accompanying workpiece holder to
guide the workpiece accurately past the saw
blade.
- Use the accompanying spacer wedge and pro-
tective cover. Make sure the cover is set as de-
scribed in the operating instructions.
- Use a suitable device to support long work-
pieces and ensure that they are horizontal.
- Pull the plug from the main power socket be-
fore changing tools and rectifying faults such
as removing trapped splinters.
- Do not remove offcuts or other workpiece
parts from the cutting area while the tool is
still running and until the saw blade stops.
- If the saw blade is blocked, switch the machine
off immediately and disconnect the mains
plug. Do not remove the jammed workpiece
until you have done this.
- Cutting rebates or grooves is only permitted
with a suitable protective device fi tted, e.g. a
protective tunnel over the saw table.
- Do not use circular saws for cutting slots
(grooves in workpiece).
- Before transporting the machine, make sure
that the top protective guard covers the top
section of the saw blade.
- Do not use the top protective cover as a handle
for transportation!
- When not in use, store the push stick in the
holder provided on the machine.
5.2

Emission levels

Noise emissions have been measured in accord-
ance with the specifi cations in EN 61029. These
specifi cations apply for operation as a trimming
saw and bench-mounted circular saw.
Noise level
Sound power level, idling
Sound power level,
during operation
Measuring uncertainty allowance
Workplace emission levels
Workplace emission, idling
Workplace emission,
during operation
CAUTION
The noise produced during work may damage
your hearing.
Wear ear protection!
Measured acceleration
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
P R E C I S I O
- GB
91 dB(A)
103 dB(A)
K = 3 dB
77 dB(A)
90 dB(A)
< 2.5 m/s²
15