Installation With 3-Point Safety Belt; Installation With 3-Point Safety Belt In Combination - Foppapedretti BEST duoFIX Instrucciones De Montaje

• ENGLISH •
CHECKS BEFORE USE

5. INSTALLATION WITH 3-POINT SAFETY BELT

1. Please make sure that the both smart fix connectors are stowed in its
original position (the most inside position). If not, please pull&hold the smart fix
adjustment button, meantime push back the smart fix arms back into the seat
base. Repeat the above, to pull back the arm in the other side.(5-A)
2. Place the child seat on the vehicle seat, make sure the backrest of child seat
is flush with 2. Place the child seat on the vehicle seat, make sure the backrest
of child seat is flush with backrest of the vehicle seat. Tips: if the headrest of the
vehicle seat gets in the way, please remove it or turn it in other way.(5-B).
3. SFollow the steps in section 7 "Securing your child" to finish the installation.
6. INSTALLATION WITH 3-POINT SAFETY BELT IN COMBINATION WITH
SMART FIX CONNECTORS
Please read the instructions on the use of child restraint systems described in your
vehicle owner's manual. Find the ISOFIX anchorage points in the vehicle seat.
Tips: the ISOFIX anchorage points are located between the surface and the
backrest of the vehicle seat.
1. Insert two Smart Fix guides to the ISOFIX lower anchorages respectively (6-
A) Smart Fix guides make it easier to install using the Smart Fix connectors and
prevent damage to the upholstery.
2. Pull the Smart Fix extend levers on the both sides of seat base to stretch the
4-D
two arms of Smart Fix connectors respectively (6-B)
3. Line up the Smart Fix connectors with the Smart Fix guides. Attach the two
Smart Fix connectors to the two anchorages points on the vehicle seat respectively.
You will hear two sounds of "clicks". And check the Smart Fix indicator on each
side turns to green (6-C/6-D)
21