Operation - Festool PLANEX LHS 225 EQ Manual De Instrucciones

9
9- 1
Risk of injury
 Do not hold the machine by the head.
 Hold the machine with both hands.
 Make sure that all clamping levers are closed
before operating the machine.
 Connect the machine to the mains power sup-
ply.
 Before switching on, hold the sanding head a
slight distance away from the working surface.
 Switch on the machine.
 The on/off switch has a zero voltage actuator,
which prevents the machine from starting auto-
matically after the power supply is interrupted
(e.g. after a power failure). After an interrup-
tion in voltage, press the on/off switch [1-4] to
switch the machine on again.
 Perform the necessary sanding work.
 Do not overload the machine by pressing with
excessive force! The best sanding results are
achieved with moderate press-on pressure.
The sanding performance and quality are
mainly dependent on the selection of the cor-
rect abrasive.
 Switch the machine off once the sanding task
is complete.
Visual warning signals on the sanding head
The following visual signals appear on the LED
[9-2] on the motor housing and the machine de-
creases in speed if necessary.
LED fl ashing slowly
The machine is overheating due to heavy dirt
deposits around the air vent slits and the dust
fi lter [9-1].
 Clean the air vent slits.
 Remove the dust fi lter [9-1].
 Remove the dirt deposits.
 Insert the dust fi lter [9-1] until it audibly en-
gages.
 The LED stops fl ashing once the machine is
9- 2
cleaned and cools down. You can then continue
with your work.
If the LED is still fl ashing after the fi lter sieve and
air vent slits have been cleaned:
 Apply less pressure on the surface.

Operation

WARNING
15