General Inspection - Triton TROS125 Instrucciones De Uso

Accessories
• A range of accessories, including punched hook and loop sanding discs with various
grit, is available from your Triton stockist. For you own safety, use only genuine Triton
accessories. Spare parts can be purchased from your Triton dealer or online
at toolsparesonline.com
Maintenance
WARNING: Always disconnect the tool from the power supply before carrying out any
maintenance/cleaning.
• This tool is manufactured using class leading components and makes use of the latest
in intelligent circuitry that protects the tool and its components. In normal use, it should
provide a long working life

General Inspection

• Regularly check that all the fixing screws are tight. They may vibrate loose over time
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised Triton service centre or technician.
This advice also applies to any extension cords used with this tool
Lubrication
• Lubricate all moving parts with a suitable lubricant spray at regular intervals
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and gloves when
cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly and
shorten the device's service life
• Clean the body of your machine with a soft brush or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild
detergent on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation holes
(where applicable)
Hook & loop surfaces
• Hook and loop surfaces need to be clean, free of dirt and foreign matter, such as hair,
fibres, sand, etc.
• In order to provide adequate adhesion for securing accessories, hook and loop surfaces
must be in good condition
• When used extensively, hooks and loops will become elongated or broken, and the
mechanism cannot provide the required strength of adhesion anymore
• Note: This sander's Hook & Loop Backing Pad is NOT a warranty item. Replacement
backing pads can be obtained as spare parts through an authorised Triton service centre.
Storage
• Store this tool and its accessories after use in its case, in a dry, secure place out of the
reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
GB
7