Fastening The Buckle; Releasing The Buckle; Using The Chest Clip; Using The Recline - Britax FRONTIER Guia Del Usuario

Child Seat Functions

Fastening the Buckle

Insert one tongue at a time into
the buckle.
NOTE: Proper connection is
confirmed with an audible click
after inserting each buckle
tongue.

Using the Chest Clip

Squeeze to Push together to fasten
1 1
open
NOTE: Always position the chest clip at
armpit level.

Using the Recline

IMPORTANT: This child seat cannot be in the recline position when
used in booster mode.
Pull the recline adjustment
1
handle and adjust the seat to
the desired position.
* Adjust the seat and ensure that
it is locked into the desired
position before installing in the
vehicle.
* Ensure the top of the child seat
does not rest against the
top of the vehicle seat back
while reclining.
* Pay attention while adjusting
the recline to keep hands clear
of any pinch point.
24

Releasing the Buckle

Press the release button and
pull the tongues from the
buckle.
NOTE: Periodically clean
the buckle to ensure proper
operation. See Page 44.
Upright Position
2
Recline Position
3
Using Lower Anchors and Tethers for Children (LATCH)
LATCH SYSTEM ANCHOR LOCATIONS
Lower Anchors
11 in. (27.9 cm)
Tether
Anchor
The Lower Anchors and Tethers for Children or LATCH, is a system
available on this child seat that offers an alternative to vehicle seat
belt installation methods. The figure below shows typical locations
for lower anchors and tether anchors in a vehicle. See pages 2-3 for
LATCH components on this child seat.
Check your vehicle owner's manual to learn if it is equipped with
LATCH, the maximum weight rating for the lower anchors, tether
anchors capacities, and information on the lower anchor locations
and designated seating positions available for use with this child
seat.
Child Seat Functions
Lower
Anchors
25