Stihl FC 70 Manual De Instrucciones página 12

English
In the event of an emergency, switch off
the engine immediately – move the slide
control / stop switch to 0 or STOP.
WARNING
The cutting attachment continues to
rotate for a short period after the throttle
trigger is released (flywheel effect.)
WARNING
The rotating cutting attachment may
fling foreign objects directly or by
ricochet a great distance.
15m (50ft)
To reduce the risk of eye and other injury
always wear proper eye protection (see
the chapter on "Proper Clothing") and
ensure that bystanders are at least
15 m (50 feet) away. To reduce the risk
of damage to property, also maintain this
distance from such objects as vehicles
or windows. Even maintaining a
minimum distance of 15 meters cannot
exclude the potential danger. Any
coworkers who must be in the restricted
area should also wear goggles or
protective glasses. Stop the engine
immediately if you are approached.
10
WARNING
Inspect the work area: To
reduce the risk of injury,
remove stones, pieces of
metal and other solid
objects which could be
thrown 15 meters or more
by the cutting attachment
or damage the cutting
attachment and property
(e.g. parked vehicles,
windows).
WARNING
During cutting, check the tightness and
the condition of the cutting attachment at
regular short intervals with the engine
and attachment stopped. If the behavior
of the attachment changes during use,
stop the engine immediately, wait until
the cutting attachment stops, and check
the nut securing the attachment for
tightness and the blade for cracks, wear
and damage.
WARNING
A loose blade may vibrate, crack, break
or come off the edger, which may result
in serious or fatal injury. Make sure that
the cutting attachment is properly
tightened. Use the wrench supplied or
one of sufficient length to obtain the
proper torque. If the blade loosens after
being properly tightened, stop work
immediately. The retaining nut may be
worn or damaged and should be
replaced. If the blade continues to
loosen, see your STIHL dealer. Never
use an edger with a loose cutting
attachment.
WARNING
Replace a cracked, bent, warped,
damaged, dull or worn out blade
immediately, even if damage is limited to
superficial cracks. Such attachments
may shatter at high speed and cause
serious or fatal injury.
WARNING
When using your edger, avoid cutting
close to fences, sides of buildings, tree
trunks, stones or other such objects that
could cause the power tool to kick out or
could cause damage to the blade.
WARNING
If the blade or deflector becomes
clogged or stuck, always shut off the
engine and make sure the cutting
attachment has stopped before
cleaning. Grass, weeds, etc. should be
cleaned off the blade at regular intervals.
WARNING
To reduce the risk of unintentional
rotation of the cutting attachment and
injury, always shut off the engine before
replacing the cutting attachment.
WARNING
The gearbox becomes hot during
operation. To reduce the risk of burn
injury, do not touch the gear housing
when it is hot.
WARNING
Never modify your muffler. Any
modification could cause an increase in
heat radiation, sparks or sound level,
FC 70 C