Installing Blade Cover - Maruyama BCV5020 Manual Del Usuario

Brushcutter Blade
POTENTIAL HAZARD
・If the Brushcutter blade is not adequately tightened, it can come loose from the Brushcutter
during use.
WHAT CAN HAPPEN
・This may cause damage to property or personal injury.
HOW TO AVOID THE HAZARD
・Make sure the Brushcutter blade is securely fastened to the attaching shaft in the gearcase.
1. Remove the blade nut, stabilizer and clamping washer from the attaching shaft out of the gearcase.
Note: The blade nut has left-hand thread.

POTENTIAL HAZARD
・Brushcutter blade is sharp.
WHAT CAN HAPPEN
・Contact with sharp blade can cause personal injury.
HOW TO AVOID THE HAZARD
・Wear gloves when you handle the blade.
2. Install the brushcutter blade onto the boss adapter, then
reinstall the clamping washer, stabilizer and blade nut.
3. Align the hole in the boss adapter with the guide hole in the
gearcase.
4. Insert theφ6mm pin into the hole in the boss adapter and
the hole in the gearcase to lock the attaching shaft.
5. Tighten the blade nut.
6. Remove theφ6mm pin from the boss adapter and gearcase.

Installing Blade Cover

POTENTIAL HAZARD
・Brushcutter blade is sharp.
WHAT CAN HAPPEN
・Contact with sharp blade can cause serious personal
injury.
・An unprotected blade is subject to damage.
HOW TO AVOID THE HAZARD
・Keep the blade cover on the blade when the Brushcutter
is not use. This will protect persons from injury from
blade contact, and will protect the blade from damage.
Attach the blade cover to the brushcutter blade as shown.

CAUTION

CAUTION
WARNING
Left-hand
thread
― GB-8 ―
Blade Nut
Stabilizer
Washer
Brushcutter Blade
Gearcase
Holding Tool
(φ6mm Pin)
Blade Cover
Attaching
Shaft
Boss
Adapter
Brushcutter
Blade