Installing Debris Shield; Cutting Blade - Maruyama BC360HT Manual Del Propietario - Operador

INSTALLING DEBRIS SHIELD

DEBRIS SHIELD
Attach the debris shield to the shaft assembly as close to the
gearcase as possible with two M6x30 screws as shown.

CUTTING BLADE

A variety of metal cutting blades are available to satisfy
different cutting conditions. It is especially important to use
only the correct blade(s) approved for each model brushcutter.
Also, it is especially important to install the blade for LEFT-
HAND rotation (as viewed from the operator's position), and
to correctly position all blade holding parts (see sketch).
Gearcase
Left hand
thread
Cutting
Blade
Gearcase
＿ US-5 ＿
M6×30
Screw (2)
Plate
Shaft
Assembly
Debris shield
Blade nut
Stabilizer
Washer
Boss Adapter
Holding Tool
(4mm Hex Wrench)