Battery Settings; Personalisation Using External Software - Eaton Pulsar Serie Manual De Instalación, Usuario

Battery settings

Function
Auto Battery Test
Low Batt Warning
User Batt Settings
Deep Disch Protect
4.5 Maintenance
Function
Model
Alarm History
Manual Batt Test
Led & Buzzer Test
Life Cycle Monitoring
Statistics
Operation Limits
Start other UPS

4.6 Personalisation using external software

Insert the Solution-Pac CD-ROM in the drive.
On the first navigation screen, select "Point to Point solution" and follow the instructions on how to install the
Personal Solution-Pac software.
Then select "Settings", "Advanced settings" and "UPS settings".
Note that only the Windows versions of the Personal Solution-Pac software offer this possibility.
4. Access to measurements and personalisation data
Factory setting
Everyweek
20%
UPS reads number of
battery modules
connected
Yes
Sub-Function
Power Module
Frame
Read
Erase
Manual Battery Test
Led & Buzzer Test
LCM
Auto Statistics
Custom Statistics
Operation Limits
Start other UPS?
Options Comments
No test / everyday /
everyweek /everymonth
0 to 100% 1% increment
From 0 to 40 Ah 5 Ah increment
No Protection against deep discharge.
If disable, EATON warranty will be
void
Option / Display Comments
SN: xxxxxxxxx Serial number
SOFT: xxx Soft version
Description 10 alarms can be stored
Date Hour automatically
Alarm xxx
No / Yes
No / Yes
No / Yes
Enable / Disable Life cycling monitoring alarms
Statistics
Reset Date ?
Are you sure ?
Automatic alarms displayed when
UPS is operating near the limits
No/Yes In parallel :
If yes, the load is transferred
without break* on the other UPS,
and the other UPS is enabled to
start alone (see section 5.3).
* Do not use this function on unitary UPS,
to avoid a load loss.
34008030EN/AD - Page 27