Safe Mantenance - AGM G50 Serie Manual De Instalación

• It is forbidden to overload the lift: use of the lift is allowed only and exclusively for lifting weights falling within the load capacity indicated in
the table TECHNICAL DATA.
• It is mandatory to place the motor-vehicles on the lift in a way that the weight is well distributed and centered; the doors must remain closed;
no objects shall protrude out of the motor-vehicle's outside dimensions; the motor-vehicle's center of gravity must fall within the four
rests; when some of the motor-vehicle's parts are disassembled, the center of gravity may move.
• It is forbidden to overload the lift. The use of the lift is permitted only and solely to raise loads within the maximum permissible capacity
that is listed in the "LOAD DISTRIBUTION" table (Fig. 5) and placing the vehicles on the lift in such a way as to comply, at the same time,
with following regulations contained in the european norm EN 1493:1998:
1. The weight of the vehicle to be lifted, represented by the addition of the 2 loads Q1 and Q2 (see the symbols in Fig. 5), must not
exceed the maximum lift capacity (Qmax); i.e. (Q1+Q2) ≤ Qmax
2. The maximum load Q1 (Q1max) placed indifferently on the short or on the long arms, must not exceed 3330 Kg as shown in Fig. 5,
i.e. (Q1max ≤ 3330 Kg)
AGM Srl accepts no liability for injury or damage to persons, animals and belongings as a result of negligence to observe the above
instructions and/or for any use of the lift that is not described in this manual.
• It is mandatory to install the lift on a level, smooth and horizontal floor.
• It is mandatory to install the lift close to a power socket and to connect it using a suitable plug in compliance with the country regulations.
• It is mandatory to install the lift in a place protected from water, ice and wind.
• It is mandatory that all the safety devices and the lift itself be thoroughly checked for their integrity before starting-up the lift.
• It is mandatory that the motor-vehicle to be lifted is driven and moved only by personnel suited to driving as regulated by the laws in force
in the Country in which the lift is used.
• It is mandatory to check that no foreign persons or animals are within or near the danger areas (Fig. 5) before starting-up the lift.
• We recommend that you familiarize yourself with the control devices and their functions before beginning operation.
• We recommend to pay careful attention when you raise the lift in order not to crush the motor-vehicle against the workshop's ceiling, since
motor-vehicles come in different sizes.
• Before you raise the motor-vehicle, it is mandatory that you raise it first only 10 cm. as a test, thereby checking the load's stability.
• We recommend that before lowering the bridge, you check that no objects are around or underneath the motor-vehicle; in case, remove
them.
• It is obligatory to lower the bridge and rotate the Emergency cut-off switch (19 Fig.2) to the OFF position before leaving the workstation.
• It is strictly forbidden to modify the hydraulic unit in any way whatsoever (17 Fig. 3).
• It is mandatory that no equipment connected to the mains be present in the area above the lift. Electrical discharge could occur should the
lift or the motor-vehicle collide with such equipment, causing danger to persons.
• In the event of danger to persons, animals or property, rotate the Emergency cut-off switch (19 Fig.2) to the OFF position as quickly as
possible.
• If oil from the hydraulic unit comes in contact with the skin, we recommend that you wash the part with plenty of water and soap.
• It is mandatory that you raise the lift high enough so that there is enough space to have access to the motor-vehicle and walk in an up-right
position.
• It is mandatory to carry out the saddles alignement before the start-up and, when in operation, after a few up and down cycles.
• It is forbidden to work with the lift when, after a saddle alignement operation, the saddles are not perfectly aligned: the vehicle may fall
down.
• It is mandatory, in case of malfunction of the lift, to stop the operation and to contact the manufacturer or the authorized maintenance
workshop.
• It is forbidden to operate with the lift when during the use you notice malfunctions or anomalies.
To clean the lift use only a soft cloth. It is allowed to wet lightly the cloth with alcool to clean oil and grease spots. Do not use other solvents as
they may damage plastic components and painted parts.
2.6 SAFE MAINTENANCE
• It is mandatory to periodically inspect the integrity of the safety devices and of the structure of the lift.
• It is mandatory to check periodically the fastening and sealing of screws, nuts and connectors.
• It is mandatory to check that the mobile lifting devices (rollers, pins etc.), are in good condition and well lubricated.
• Only use the types of oil that are recommended.
• Spare parts must satisfy the requirements indicated by the manufacturer. Use original spare parts only.
• It is mandatory that the lift and its single components may only be moved or lifted by means of ropes, chains, cables and lifting tools that
comply with the regulations in force in the country where such operations are performed.
• It is mandatory that the installation is carried out in such a way that the lift or the motor vehicle may not crush, hook or touch other objects,
especially electric, water and gas systems.
• Removing or tampering with satety devices is strictly prohibited.
• It is mandatory that installation and maintenance of the lift be carried-out only by qualified personnel, following the directions written in this
manual.
• It is mandatory to plug out the power supply during all maintenance and repairing operations.
• Carefully follow the instructions provided in this manual; only allow qualified staff to replace damaged or worn-out parts.
• Do not weld, cut or bore on the lift structure.
• It is mandatory to carry out adjustements or interventions on the lift only after disconecting the power supply.
30
• If the instruction labels placed on the lift which indicate the necessary advice to avoid accidents are dirty, it is mandatory to clean them;
when they are damaged or have been peeled off they must be changed immediately.
• We recommend that you thoroughly clean the floor of oil spills as soon as they occur because they can be very dangerous.