Editing Recorded Tracks; Erasing Tracks; To Erase A Track; To Erase The Whole Disc - Sony MZ-R90 Manual De Instrucciones

Editing recorded tracks

You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
Notes on editing
• Do not move or jog the recorder while "TOC
Edit"* is flashing in the display.
• You cannot edit tracks on an MD that is
record-protected. Before editing tracks, close
the tab on the side of the MD.
• If you perform an editing operation while
playing, be sure not to turn the power off until
"TOC Edit" disappears in the display.
• The lid does not open until "TOC Edit"
disappears in the display after editing.
∗ TOC = Table of Contents

Erasing tracks

To erase a track

Note that once a recording has been
erased, you cannot retrieve it. Make sure
of the track you are erasing.
Jog lever
x
1
While playing the track you want to
erase, press the jog lever so that
"EDIT" flashes in the display, and
then press the lever again.
" : Name" flashes in the display,
and the recorder plays the selected
track repeatedly.
T MARK
2
Flip the jog lever until "
flashes in the display, and then press
the lever.
"Erase OK?" and "PushENTER"
appear alternately in the display.
To cancel erasing, press x or T
MARK.
3
Press the jog lever again.
The track is erased and the next track
starts to play. All the tracks after the
one erased are automatically
renumbered.
To erase a part of a track
Add track marks at the beginning and the
end of the part you want to erase, then
erase the part.

To erase the whole disc

You can quickly erase all the tracks and
data of the MD at the same time.
Note that once a recording has been
erased, you cannot retrieve it. Be sure to
check the contents of the disc you want to
erase.
Jog lever
x
1
While the recorder is stopped, press
the jog lever so that "EDIT" flashes in
the display, and then press the lever
again.
" : Name" flashes in the display.
: Erase"
T MARK
continued
29
-GB