Air Filter System - Stihl Cutquik TS 700 Manual De Instrucciones

Air filter system

3
2
3
1
Fouled air filters will impair engine
performance, increase fuel consumption
and make the machine more difficult to
start.
If there is a noticeable loss of
engine power
:
Remove the locking screw (1) on
the filter cover.
:
Remove the filter cover (2).
: Remove all coarse dirt from the area
around the filter and the inside of the
filter cover.
TS 700
5
4
3
3
The main filter and auxiliary filter should
only be serviced at headquarters or at a
service branch.
:
Remove the screws (3).
:
Remove the filter housing (4).
: Pull the main filter (5) out of the filter
housing and examine it. It must be
replaced if fouled or damaged.
Always install a new auxiliary filter
when changing the main filter.
: Set choke lever to g
6
: Pull the auxiliary filter (6) off the filter
base and examine it. It must be
replaced if damaged. Ensure that
dirt does not enter the intake area
when removing the auxiliary filter.
:
Clean the filter area and refit all filter
components.
:
Refit the filter cover.
:
Tighten down the locking screw.
Filter system
The quality of the filter elements is
particularly important on account of the
special operating conditions in which
cut-off machines are used (extremely
high dust loads and high dynamic
stresses).
STIHL air filters are specially developed
for use in cut-off machines and therefore
meet with particular requirements as
regards their mechanical design, the
materials used and the quality of their
manufacture:
– Extremely uniform pore size, folds
and mechanical strength of the filter
paper.
– High compressive strength and
dimensional accuracy of the filter
cartridges
English / USA
29