Cleaning/Replacing The Flat Pleated Filter; Transport; Storage; Care And Maintenance - Kärcher Puzzi 30/4 Manual Del Usuario

– Do not step on cleaned surfaces until
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.
– When cleaning previously shampooed
carpets, foam will be generated in the
dirt water reservoir. In such a case add
Foam ex RM 761 to the dirt water reser-
voir.
Detergent
Carpet and upholstery
cleaning
Defoaming
Waterproofing carpets
For further information, please request
product information sheet and EU safety
data sheet of the relevant detergent.

Transport

CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Grab the appliance by the chassis and
by the sliding bow to load it.
 Pull the device behind you at the carry-
ing handle for transporting it over longer
distances
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Care and maintenance

DANGER
Danger of injury by electric shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
12
RM 760 powder
RM 760 tabs
RM 764 liquid
RM 761
RM 762

Storage

Cleaning/replacing the flat pleated
Note: With normal use, clean the flat pleat-
ed filter weekly, or even earlier if the suction
performance is decreasing.
Note: Use a commercially available house-
hold sponge made of soft material in order
to avoid damaging the coated lamellae.
 Unlock the bonnet, swivel it upwards
and snap it in place at the locking devic-
es.
 Unlock and remove the filter casing.
 Take out the flat folded filter.
Illustration
 Clean the individual lamellae of the flat
pleated filter under running water using
the sponge.
 Allow the filter to dry completely.
 Replace the flat pleated filter at least
every 12 months with normal use, re-
place earlier as necessary.
Note: The flat pleated filter must be dis-
posed of in the residual waste.
Clean the fluff filter
 Unlock the bonnet, swivel it upwards
and snap it in place at the locking devic-
es.
 Unlock and remove the filter casing.
 Take out the flat folded filter.
 Unscrew the swimmer.
 Clean the fluff filter.
Cleaning the fresh water sieve
 Unscrew the fresh water sieve incl. the
lid.
 Clean the fresh water sieve.
Cleaning the nozzle
 Unscrew the covering nut.
 Clean nozzle mouthpiece.
– 5
EN
filter