Care And Service; Cleaning The Suction Mouth And Suction System; Cleaning The Recycling System; Draining Waste Water / Recycling Water - Kärcher MC 250 Implementos

1.6

Care and service

1.6.1 Cleaning the suction mouth and suction system

Flush the suction system with water daily after finishing
work.
Figure: Cleaning the suction mouth and suction system
1. Park the vehicle.
2. Switch on the working hydraulics.
3. Switch on ECO mode.
4. Select an engine speed of 1550 rpm.
5. Raise the side brushes.
6. Place the water jet in the area of the suction mouth for
approx. 3 minutes. The suction mouth and suction sys-
tem are rinsed and cleaned.
7. The waste water collects in the waste container. Drain
the waste water if necessary. See chapter "Draining
waste water / recycling water".

1.6.2 Cleaning the recycling system

Clean the recycling system with water every day after fin-
ishing work.
Figure: Cleaning the recycling system
1. Park the vehicle.
2. Clean the recycling system with a water jet.

1.6.3 Draining waste water / recycling water

Drain the waste water or recycling water only in a suitable
area.
34
Figure: Draining waste water / recycling water
1. Park the vehicle in a suitable area for draining.
2. Switch on the vehicle and press the Drain recycling wa-
ter switch.
3. Drain the waste water or recycling water.

1.6.4 Cleaning the waste container

Clean the suction mouth and the suction system first be-
fore cleaning the waste container. See chapter "Cleaning
the suction mouth and suction system".
Interior of waste container
1
Side channels
2
Rod engaged
3
Blower flap
4
Retaining clip
5
Exhaust grille
6
1. Park the vehicle.
2. Raise the waste container into the emptying position.
3. Rinse the inside of the sweep container and the side
channels with water.
4. If necessary, rinse the exhaust grille with water by pull-
ing out the retaining clips on the left and right and pivot-
ing the blow-out grille down.
5. Rinse the outside of the blower flap with water, first open
the blower flap with the rod (the rod engages).

1.6.5 Cleaning the vehicle

The vehicle with the waste container can be cleaned with
a high-pressure cleaner.
 Clean critical areas such as bearings, tyres, etc. with re-
duced pressure and without a rotary nozzle.
English