HumanTechnik Lisa combi I RF Instrucciones De Servicio página 12

It is possible that the transmit signal
may be triggered once when you
connect the battery.
2. Setting the correct radio
channel
A special digital transmission pro-
cess ensures that the radio signals
are picked up without errors. This
process also makes it possible to set
10 different radio channels.
When supplied from the factory, all
combi I RF transmitters are set to
channel 0.
It is only necessary to set units to
other channels if you have several
different users operating units in the
same building.
Set the channel you want by adju-
sting the channel selector switch on
the left-hand side of the unit to the
required channel number. Use a
small screwdriver to adjust this
switch.
All transmitters and receivers must
be set to the same channel.
3a. Installing the galvanic tele-
phone cable
Plug the end of the cable with the
transparent clip-in connector (6-pin
plug) into the socket on the undersi-
de of the combi I RF transmitter.
Plug the other end into a space tele-
phone socket.
12 English
➡
Setting the correct radio channel
Important
Please only use the telephone cable
supplied with the unit, otherwise
proper function cannot be guaran-
teed.
The telephone transmitter is
designed to be connected to an
analog telephone system.
Use the Radio Telephone Transmitter
– Acoustic if your phone system is
ISDN or part of a PBX (exchange)
system.
3b. Installing the doorbell cable
Plug the 2.5 mm jack plug of the
doorbell cable into the socket on the
underside of the combi I RF trans-
mitter. Connect the two bare wires
to your doorbell.