Accessories - Hilti PMP 34 Manual De Instrucciones

2.2 Features
Highly accurate horizontal and vertical beams (±3 mm at 10 m).
Self-levelling to within ±5° in all directions.
Short self-levelling time: ~3 seconds
Warning signal "Out of self-levelling range" when the self-levelling range is exceeded (the laser beams blink).
Robust, impact-resistant plastic casing.
Small and light - easy to use and easily transportable.
Automatic cut-out: The tool switches itself off automatically after 15 minutes. Sustained operating mode may
be selected if desired.
Easy to operate.
2.3 Information displayed during operation
LED
Laser beam
2.4 Items supplied with the point laser (cardboard box version)
1 PMP 34 F point laser
1 Soft pouch
4 Batteries
1 Operating instructions
2 Target plate
1 Manufacturer's certificate

3. Accessories

Target plate (CM)
Target plate (IN)
Soft pouch
Hilti toolbox
Laser visibility glasses
Printed: 07.07.2013 | Doc-Nr: PUB / 5071513 / 000 / 00
LED doesn't light.
LED doesn't light.
LED doesn't light.
The LED lights con-
stantly.
The LED blinks.
The LED blinks.
The laser beam blinks
twice every 10 seconds.
The laser beam blinks
rapidly.
The laser beam blinks
rapidly.
PMA 50
PMA 51
PMA 60
PMP 34 F
PUA 60
The tool is switched off.
The batteries are exhausted.
The batteries are inserted incorrectly.
The laser beam is switched on. The tool is in opera-
tion.
The batteries are almost exhausted.
The temperature of the tool is above 40 °C (104 °F)
or below -10 °C (14 °F) (laser beam doesn't light.)
The batteries are almost exhausted.
Movement of the pendulum is blocked.
The tool cannot level itself.
en
13