Care And Maintenance; Cleaning And Drying; Troubleshooting - Hilti PMP 34 Manual De Instrucciones

8. Care and maintenance

8.1 Cleaning and drying

1. Blow dust off the lenses.
2. Do not touch the glass with the fingers.
3. Use only a clean, soft cloth for cleaning. If
necessary, moisten the cloth slightly with pure
en
alcohol or a little water.
NOTE Do not use any other liquids as these may
damage the plastic components.
4. Observe the temperature limits when storing
your equipment. This is particularly important in
winter / summer if the equipment is kept inside a
motor vehicle (-20°C to +63°C / -4°F to 145°F).

9. Troubleshooting

Fault
The tool can't be switched on.
Individual laser beams don't
function.
The tool can be switched on
but no laser beam is visible.
Automatic leveling doesn't
function.
18
Printed: 07.07.2013 | Doc-Nr: PUB / 5071513 / 000 / 00
8.2 Storage
Remove the tool from its case if it has become wet.
The tool, its carrying case and accessories should
be cleaned and dried (at maximum 40°C / 104°F).
Repack the equipment only once it is completely dry.
Check the accuracy of the equipment before it is used
after a long period of storage or transportation.
Remove the batteries from the tool before storing it
for a long period. Leaking batteries may damage the
tool.
8.3 Transport
Use the Hilti toolbox or packaging of equivalent quality
for transporting or shipping your equipment.
CAUTION
Always remove the batteries before shipping the
tool.
Possible cause
The battery is exhausted.
The battery is inserted the wrong
way round (incorrect polarity).
The battery compartment is not
closed.
The tool or selector switch is faulty. If necessary, have the power tool
The laser source or laser control
unit is faulty.
The laser source or laser control
unit is faulty.
The temperature is too high or too
low.
The tool is set up on an excessively
inclined surface.
The pendulum is locked.
Extraneous light is too bright.
The tilt sensor is faulty.
Remedy
Replace the battery.
Insert the battery correctly.
Close the battery compartment.
repaired by Hilti Service.
If necessary, have the power tool
repaired by Hilti Service.
If necessary, have the power tool
repaired by Hilti Service.
Allow the tool to cool down or
warm up.
Set up the tool on the level.
Release the pendulum.
Reduce extraneous light.
If necessary, have the power tool
repaired by Hilti Service.