Pp 10 / 25 Pipe Laser; General Information - Hilti PP 10 Manual De Instrucciones

ORIGINAL OPERATING INSTRUCTIONS

PP 10 / 25 pipe laser

It is essential that the operating instructions
en
are read before the tool is operated for the
first time.
Always keep these operating instructions to-
gether with the tool.
Ensure that the operating instructions are
with the tool when it is given to other persons.
Contents

1 General information

2 Description
3 Accessories
4 Technical data
5 Safety instructions
6 Before use
7 Operation
8 Care and maintenance
9 Troubleshooting
10 Disposal
11 Manufacturer's warranty - tools
12 FCC statement (applicable in US) / IC
statement (applicable in Canada)
13 EC declaration of conformity (original)
1 These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cover
pages. Keep these pages open while studying the oper-
ating instructions.
In these operating instructions, the designation "the tool"
always refers to the PP 10/25 pipe laser.
PP 10 / 25 pipe laser 1
Remote control signal receiving window
@
Warning / standby LED
;
1 General information
1.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
14
Control panel
=
Display
%
Grip
&
Grip mount
(
PPA 84 cable connector
)
Battery compartment cover lock
+
PPA 82 battery incl. mains adaptor
§
Plumb spot
/
PP 10 / 25 pipe laser
Laser exit window
:
Remote control signal receiving window
Page ·
Plumb spot
14
$
Pivot point mark
16
£
16
Control panel
17
Direction control / auto-centering button
18
|
Plumb spot button
19
¡
Laser beam mode button
20
Q
Remote control signal receiving window
23
W
"Lock" button
24
E
Target plate auto-centering button
24
R
Direction control / auto-centering button
25
T
SET button
Z
Laser beam up / down, value-entry button
25
U
Warning / standby LED
26
I
Laser beam up / down, value-entry button
O
ON / OFF button
P
PRA 20 remote control unit 2
Signal transmission aperture
@
Signal LED (blinks red when a signal is transmitted)
;
Target plate auto-centering button
=
Self-centering buttons (press both simultaneously)
%
Button to move target axis to the left
&
Button to move target axis to the right
(
ON / OFF button
)
Laser beam mode button
+
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
NOTE
Draws attention to an instruction or other useful informa-
tion.