Making The Hood Opening - Daikin EHSX04P30D Instrucciones De Instalación Y Mantenimiento

4 Set-up and installation
Fig. 4-17 Aligning the heating inflow and return flow upwards
2 Pull the two plug brackets off the connection couplings
4-17, item C).
3 Pull off the two connection couplings
Fig. 4-18 Hydraulic system plug connectors
4 Remove the retaining plate (Fig.
5 Pull off the sealing plug bracket
6 Pull out the sealing plug (Fig.
7 Turn the elbow (Fig. 4-17, item H) 90° to the rear.
8 Pull the plug bracket off the manifold
9 Carefully pull the manifold (Fig.
out of its horizontal mounting that the retaining plate
item A) can be pushed vertically in between.
Installation and maintenance instructions
18
(Fig.
(Fig. 4-17, item B).
4-17, item A).
(Fig. 4-17, item D).
4-17, item E).
(Fig. 4-17, item G).
4-17, item F) so far backwards
(Fig. 4-19,
Fig. 4-19 Heating inflow and return flow connections aligned to the
rear
10 Slide the retaining plate between the manifold and its horizontal
mounting and insert the manifold
mounting through the middle hole of the retaining plate.
11 Secure the manifold with plug bracket
mounting again.
12 Insert the two connection couplings
lateral mountings through the retaining plate.
13 Secure the two connection couplings with plug bracket
4-19, item C) in their mountings.
14 Insert the sealing plug (Fig.
ing.
15 Secure the sealing plug with plug bracket
16 Cut out side openings in the thermal insulation
item A) using a suitable tool.
Fig. 4-20 Cut-out in thermal insulation
4.4.8

Making the hood opening

1 With the heating inflow and return flow directed upwards: Cut the
hood along the perforation with a suitable tool.
(Fig. 4-19, item F) back into its
(Fig. 4-19, item G) in its
(Fig. 4-19, item B) into the
(Fig.
4-19, item E) into the upper mount-
(Fig. 4-19, item D).
(Fig. 4-20,
Daikin Altherma EHS(X/H)
Daikin Altherma integrated solar unit
008.1444099_00 – 07/2018 – EN