Connecting The Drain - Daikin EHSX04P30D Instrucciones De Instalación Y Mantenimiento

Fig. 4-27 Fix the hydraulic block in place when connecting to the
top (left) or to the rear (right)
3 Establish hydraulic connections on the Daikin Altherma EHS(X/
H).
▪ Refer to Chap. 4.1 for the position of the heater connections.
▪ Observe specified tightening torque (see
▪ Install the line in such a way that the protective cover of the
Daikin Altherma EHS(X/H) is simple to put on after assembly.
▪ Connect the water for filling or refilling the heating system as
specified by EN 1717/EN 61770 to avoid contamination of
drinking water by return flow.
4 For rearward facing connections: Support hydraulic lines suit-
ably according to the spatial conditions.
Fig. 4-28 Connection to the rear: Support hydraulic lines
5 Connect the blow-off line to the safety over-pressure valve and
diaphragm expansion vessel in accordance with EN 12828.
▪ Any steam or heating water which may escape must be drained
by a suitable blow-off line with constant gradient in a frost-pro-
tected, safe and observable manner.
▪ Install the line in such a way that the protective cover of the
Daikin Altherma EHS(X/H) is simple to put on after assembly.
▪ Check the seat of the drain hose on the safety pressure relief
valve. If necessary, connect and install a separate hose.
6 Connecting a diaphragm expansion vessel.
▪ Connect a suitably dimensioned and preset diaphragm expan-
sion vessel for the heating system. There may not be any hy-
draulic blocking elements between the heat generator and the
safety valve.
▪ Position the diaphragm expansion vessel in an easily access-
ible place (maintenance, parts replacement).
Daikin Altherma EHS(X/H)
Daikin Altherma integrated solar unit
008.1444099_00 – 07/2018 – EN
7 Carefully insulate pipework against heat loss and to avoid con-
densation (insulation thickness at least 20 mm).
– Water shortage protection: The pressure and temperature
monitoring of the controller shuts off and locks the Daikin
Altherma EHS(X/H) safely if there is a shortage of water. No
additional water shortage protection is needed in the con-
struction.
– Avoid damage caused by deposits and corrosion: see
Chap. 1.2.5
Chap. 10.3)
Fig. 4-29
4.6.2
1 Connect the drain hose to the hose connecting piece for the
safety overflow
– Use transparent drain hose (draining water must be visible).
– Connect the drain hose to an adequately dimensioned waste
water installation.
– Drain should not be lockable.
Fig. 4-30
4 Set-up and installation
Connecting a diaphragm expansion vessel

Connecting the drain

(Fig. 3-1, item 23).
Connection of the overflow hose
Installation and maintenance instructions
21