Cembre SD-9P-ECO Manual De Uso página 7

FIG. 1 SETTING THE DRILLING MACHINE - PREPARATION DE PERCEUSE
VORBEREITUNG DER BOHRMASCHINE - PREPARACION DE LA
TALADRADORA - PREPARAZIONE DEL TRAPANO
28
12
27
14
16
17
20
25 26
23
24
22
FIG. 2 SPINDLE CHANGE
Spindle
CHANGEMENT DE BROCHE
Broche
WECHSELN DER SPINDEL
Spindel
CAMBIO DEL MANDRIL
Mandril
CAMBIO DEL MANDRINO
Mandrino
19
4. DRILLING
4.1) Preparing the drilling machine
Remove drilling machine, detachable guard and
auger from storage case.

Stop the engine before removing the auger
4.1.1) Fitting and removing the auger (See Fig. 1)
Select the auger suitable for the work to be done:
– Turn the emergency lever (12) and fully insert the auger.
– Release the emergency lever.
– Manually rotate the auger until a click is heard, indicating automatic locking.
To remove the auger: turn the emergency lever, manually rotate and remove the auger
from the spindle.
4.1.2) Assemble the guard PRM-U (See Fig. 1)
To fit the detachable guard PRM-U (22), complete with end piece (33), proceed as follows:
– Unscrew the guard knob (23) from each shaft (25).
– Slide the shafts (25) into the brass bushes on the detachable guard (22): until they
protrude sufficiently, to enable the guard nuts (23) to be fitted.
Tighten the guard nuts (23) by hand.
The SD-9P-ECO drill is supplied complete with TPM 200-26 end piece; should it need to
be replaced, simply unscrew it by hand and screw on the new end piece suitable for the
centring required.
Slide the guard bushes onto the shafts then screw a guard knob onto each one.
33
4.1.3) Setting the hole depth (See Fig. 1)
Open the lever and loosen the adjuster (27).
Position the adjuster to the desired depth on the graduated scale. Tighten the adjuster
and close the lever (24).
During the drilling operation, the adjuster butts against the detachable guard at the preset
hole depth to prevent any further travel of the auger.
4.2) USING THE DRILLING MACHINE
The drilling machine can be used independently or in conjunction with the support trolley:
4.2.1) Using the drilling machine "independently" (Ref. to Fig. 5)
18
With the drilling machine on the ground follow the instructions in § 7.
Allow the machine to "warm up" for 2 minutes prior to commencement of work.
Locate the machine on the sleeper in the desired position, locate the guard end piece (33)
into the bush of the chair and proceed as § 4.3.
53 6
ENGLISH