Safety Instructions Regarding Batteries - NORAUTO START PRO 2223451 Instrucciones De Uso

case, do not use the appliance but return it to your retailer for
inspection and repair.
4The indicated voltage on the rating label matches with your
electrical installations.
- Position the battery charger as far away from the battery as the
leads will allow.
- Explosive gases may collect near the ground. Place the battery
charger as high as possible above ground level.
- Do not carry our any repairs by yourself. Any check, disassembling
or repairing has to be carried out exclusively by a qualified person.
- Do not open the casing. There are no user-serviceable parts
inside.
- Do not place the battery charger above or stand the battery
charger on top of the battery.
- The battery terminal not connected to the chassis has to be
connected first. The other connection is to be made to the chassis,
remote from the battery and fuel line. The battery charger is then
to be connected to the supply mains.After charging, disconnect the
battery charger from the supply mains. Then remove the chassis
connection and then the battery connection.
For car it is mandatory to check the tire pressure with a manometer
homologated. Indeed, the manometer of the device, while being
good quality, is not homologated and therefore NOT SUITABLE
FOR INFLATING CAR TIRES.

SAFETY INSTRUCTIONS REGARDING BATTERIES

- WARNING: Risk of explosive gas mixtures. Working in the vicinity
of a lead-acid battery is dangerous. Batteries generate explosive
gases during normal battery operation. For this reason, it is of
utmost importance that each time, before using your battery
charger, you read this manual and follow the instructions exactly.
- Check that your batteries can be recharged with this charger. For
this, refer to the manufacturer's instruction manual of the battery.
- Make sure that the initial charging rate does not exceed the battery
manufacturer's specifications.
110
Fiche murale :
LCD
%
30%
pour recharger l'appareil, connectez d'abord
la fiche du chargeur sur une alimentation de
220 V, puis connectez le port de sortie de
charge sur le port d'entrée du produit. Le
pourcentage qui s'affiche sur l'écran LCD
indique l'état de la charge. Une fois la
charge terminée, l'icône de charge située
dans la partie supérieure droite de l'écran
cesse de clignoter.
Light Power
M 2MINS
Setup Unit Inflator TEST
Voyant LED:
DÉSACTIVÉ
Voyant LED: appuyez pendant 3 secondes
sur le commutateur d'alimentation (8) pour
allumer l'appareil.
- 1Ère pression brève : lampe de travail
- 2e pression brève : torche
- 3e pression brève : arrêt de la lampe.
Arrêt après 2 min :
l'appareil s'arrête automatiquement en
cas d'inutilisation pendant 2 minutes.
Vous pouvez également appuyer
pendant 3 secondes sur le commutateur
OFF
d'alimentation (8) pour l'arrêter.
15