Stihl FS 510 C-M Manual De Instrucciones página 21

5
Use the spring (5) from the parts kit
N
supplied with the machine.
Push the spring (5) into the lower
N
clamp molding (6).
4
7
Position the clamp moldings (4) with
N
handlebar (2) on the handle support
(7).
Do notturn the handlebar in the
N
clamp moldings.
FS 510 C-M, FS 560 C-M
Raise the grip of the wing screw (8)
N
to the upright position.
Rotate the wing screw
N
counterclockwise and tighten it only
moderately.
8
2
Position wing screw (8) in threaded
N
insert in handle support (7) – against
pressure of spring (5).
Position the clamp moldings so that
N
the tabs (9) on the lower clamp
molding (6) line up with the slots
(10) in the handle support (7).
8
N
5
7
N
N
6
9
7
10
N
6
7
Rotate wing screw clockwise until
the lower clamp molding (6) butts
against the handle support (7).
2
Swing the handebar (2) forwards
through 180°.
Only tighten the wing screw
moderately.
Fold the grip of the wing screw down
so that it is flush.
English
19