Stihl FS 510 C-M Manual De Instrucciones página 30

English
Securing the cutting attachment
Fit 70 mm (2.8 in) diameter thrust
N
washer (2) – convex side must face
up.
Fit the guard ring (3) for brush
N
knives – opening must face up.
Block the shaft.
N
Screw on the nut (4)
N
counterclockwise and tighten it
down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the cutting attachment
Block the shaft.
N
Unscrew the mounting nut
N
clockwise.
Pull the cutting attachment with its
N
mounting hardware off the gearbox.
Mounting Circular Saw Blades 225
Check that the stop for circular saw
N
blades is already mounted to the
machine – if not, perform the next
two steps.
Remove grass shield – if fitted.
N
Remove deflector – if fitted.
N
Mount limit stop for circular saw
N
blades.
Fit the 65 mm (2.6 in) diameter
N
thrust plate.
28
Check direction of rotation of cutting
attachment
Cutting edges of circular saw blades
must point clockwise.
4
3
2
b
a
Place the cutting attachment (1) in
N
position.
WARNING
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Securing the cutting attachment
Fit 60 mm (2.4 in) diameter thrust
N
washer (2) – convex side must face
up.
Fit 63 mm (2.5 in) diameter rider
N
plate (3).
Block the shaft.
N
Screw on the nut (4)
N
counterclockwise and tighten it
down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
1
Removing the cutting attachment
Block the shaft.
N
Unscrew the mounting nut
N
clockwise.
Pull the cutting attachment with its
N
mounting hardware off the gearbox.
FS 510 C-M, FS 560 C-M