Stihl FS 510 C-M Manual De Instrucciones página 29

4
3
2
b
a
Place the cutting attachment (1) in
N
position.
WARNING
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Securing the cutting attachment
Fit 60 mm (2.4 in) diameter thrust
N
washer (2) – convex side must face
up.
Fit 80 mm (3.2 in) diameter rider
N
plate (3).
Block the shaft.
N
Screw on the nut (4)
N
counterclockwise and tighten it
down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
FS 510 C-M, FS 560 C-M
NOTICE
Remove the tool used to block the shaft.
Removing the cutting attachment
Block the shaft.
N
1
Unscrew the mounting nut (4)
N
clockwise.
Pull the cutting attachment with its
N
mounting hardware off the gearbox.
Mounting Brush Knives
Check that the deflector on the
N
machine is approved for brush
knives – if not, perform the next two
steps.
Remove grass shield with thrust
N
plate – if fitted.
Remove the non-approved
N
deflector.
Mount deflector for grass cutting
N
blades and brush knives.
Fit the 65 mm (2.6 in) diameter
N
thrust plate.
Check direction of rotation of cutting
attachment
Cutting edges of brush knives 350 - 3
may point in either direction – these
cutting attachments must be turned over
regularly to help avoid one-sided wear.
4
3 3
2
b
a
Place the cutting attachment (1) in
N
position.
WARNING
Collar (a) must locate in the cutting
attachment's mounting hole (b).
English
1
27