Mounting The Bike Handle - Stihl FS 510 C-M Manual De Instrucciones

English
7 Scratcher tooth circular saw blade
225
8 Chisel tooth circular saw blade 225
WARNING
Non-metal grass cutting blades, brush
knives and circular saw blades are not
approved.
Deflectors, Limit Stop
9 Deflector for mowing heads
10 Deflector for metal cutting
attachments, items 5 and 6
11 Limit stop for circular saw blades
Harness
12 Full harness must be used
WARNING
Based on the cutting attachment being
used:
Choose the proper deflector in order to
reduce the risk of injury from thrown
objects and contact with the cutting
attachment.
Make sure your unit is equipped with the
proper handle and harness in order to
reduce the risk of injury from loss of
control and contact with the cutting
attachment.
Use grass cutting metal blades, brush
knifes and circular saw blades on this
unit only if equipped with a bike handle.
Do not use rigid polymer blades on this
unit.
18

Mounting the Bike Handle

Mounting Bike Handle with Swiveling
Handle Support
1
Do not rotate the control handle (1)
between unpacking and mounting it on
the handlebar; see also chapter on
"Adjusting the Throttle Cable".
The brushcutter is available with two
different handlebars:
2
4
2 Handlebar for machines used
primarily for mowing and
brushcutting, but also for occasional
sawing.
4
3
3 Handlebar for machines used
mainly for sawing, but also for
mowing and brushcutting.
The machine is supplied with the clamp
moldings (4) mounted on the handlebars
(2, 3).
Do not change the position of the
N
clamp moldings on the handlebar
until it is mounted on the handle
support.
The mounting procedure is the same for
both types of handlebar. Therefore, the
following description only shows
handlebar (2).
Mounting the Handlebar
Assembly of the swivelling handle
support involves equipping the clamp
moldings with a spring and mounting
them on the handle support.
FS 510 C-M, FS 560 C-M