Stihl FS 510 C-M Manual De Instrucciones página 38

English
3
2
Remove the screw (3) from the
N
shutter.
Pull the shutter (2) out of the
N
shroud.
Rotate the shutter (2) from the
N
summer position to the winter
position and refit it.
Secure the shutter in position with
N
the screw (3).
At temperatures between
+50°F (+10°C) and +70°F (+20°C)
The machine can normally be operated
in this temperature range with the
shutter (2) in the summer position.
Change the position of the shutter if
necessary.
36
At temperatures above +70°F (+20°C)
2
Always return the shutter (2) to the
N
summer position.
NOTICE
Do not operate the machine in the winter
position at temperatures above
+70°F (+20°C) because there is
otherwise a risk of engine running
problems and overheating.
At temperatures below +14°F ( - 10°C)
In extreme wintry conditions
Temperatures below +14°F ( - 10°C)
–
Powder or drifting snow
–
it is advisable to use the optional "cover
plate kit".
5
The cover plate kit contains the following
parts for converting the power tool:
4 Cover plate partially blanks off the
slots in the starter housing
5 Synthetic fabric filter element for the
air filter
Instructions for converting the
–
machine
After installing the cover plate kit:
Set the shutter (2) to the winter
N
position.
At temperatures above +14°F ( - 10°C)
Remove the parts of the cover plate
N
kit and refit the standard parts for
summer operation.
Depending on the ambient temperature:
Set the shutter (2) to the summer or
N
winter position.
Cleaning the Air Filter
Loosen filter cover mounting
N
screws.
Remove the filter cover.
N
FS 510 C-M, FS 560 C-M
2
4