Stihl FS 56 Manual De Instrucciones página 22

English
Adjusting and Securing the Loop Handle
A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 15 cm (6 in)
Loosen the screw on the handle.
N
Slide the handle to the required
N
position.
Tighten down the screw so that the
N
handle cannot be rotated on the
drive tube.
Version B
A factory-new machine comes with the
loop handle already mounted.
20
Using the Barrier Bar
A barrier bar may have to be mounted to
suit the cutting attachment you intend to
use – see "Approved Combinations of
Cutting Attachment, Deflector, Handle
and Harness".
The barrier bar comes standard with the
machine or is available as a special
accessory.
Mounting the Barrier Bar
1
1
2
2
5
5
3
3
Take out the screws (1) and remove
N
along with washers (2) and nuts (3).
Remove the loop handle (4) and
N
clamps (5).
FS 56, FS 56 R, FS 56 C, FS 56 RC
4