2
1
2
1
Push the throttle cable (1) into the
N
retainer (2).
FS 56, FS 56 R, FS 56 C, FS 56 RC
Mounting the Loop Handle
The loop handle comes in two different
versions.
Version A
A factory-new machine comes with the
loop handle already mounted.
Using the Barrier Bar
A barrier bar may have to be mounted to
suit the cutting attachment you intend to
use – see "Approved Combinations of
Cutting Attachment, Deflector, Handle
and Harness".
The barrier bar comes standard with the
machine or is available as a special
accessory.
Mounting the Barrier Bar
1
3
Fit the washer (1) on the M5x23
N
screw (2).
Hold the barrier bar (3) against the
N
loop handle and insert the screw
with washer.
Tighten down the screw (2) firmly.
N
Leave the barrier bar permanently
mounted to the loop handle.
English
0.2 in
(5,3 mm)
2
19