Stihl FS 56 Manual De Instrucciones página 23

2
1
Fit the square nuts (1) in the barrier
N
bar (2); the holes must line up.
FS 56, FS 56 R, FS 56 C, FS 56 RC
4
1
5
6
7
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Place the clamp (6) against the
N
drive tube.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) in the holes
N
and screw them into the barrier bar
as far as stop.
Go to "Adjusting and Securing the
N
Loop Handle".
Leave the barrier bar permanently
mounted to the loop handle.
2
3
7
Adjusting and Securing the Loop Handle
A
9
10
Secure the loop handle (4) about
N
15 cm/6 in (A) forward of the control
handle (9).
Line up the loop handle.
N
Tighten down the screws firmly –
N
lock the nuts if necessary.
English
4
21