Mounting The Cutting Attachment - Stihl FS 56 Manual De Instrucciones

Mounting the deflector
Deflectors (1) and (2) are both mounted
to the gearbox in the same way.
Position the deflector against the
N
gearbox so that the lug (3) engages
the recess (4) in the deflector.
Insert the screw (5) and tighten it
N
down firmly.
On some versions the M5x14 screw is
packed loose with the deflector.
FS 56, FS 56 R, FS 56 C, FS 56 RC
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Fitting the Thrust Plate
The machine comes standard with the
thrust plate.
1
Slip the thrust plate (1) over the
N
shaft (2).
NOTICE
The thrust plate on the gearbox is
necessary for mounting cutting tools.
Mounting Hardware for Cutting
Attachments
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
If mounting hardware is not packed with
machine
2
Only mowing heads may be used which
mount directly to the shaft (2).
If mounting hardware is packed with
machine
Mowing heads and metal cutting tools
may be mounted.
English
23