Mounting The Bike Handle - Stihl FS 56 Manual De Instrucciones

Ocultar thumbs Ver también para FS 56:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English

Mounting the Bike Handle

Mounting the Handlebar
Mount the handlebar on the drive tube
about 10 cm (4 in) forward of the engine
housing.
3
5
4
1
6
Place the handle support (1) on the
N
drive tube (2).
Place the handlebar (3) in the
N
handle support.
Fit the clamp (4) on the handle
N
support. Insert the screws (5)
through the holes in the parts and
screw them into clamp (6) as far as
stop – tighten them only moderately
at this stage.
18
Mounting the Control Handle
3
2
Take out the screw (1) – the nut (2)
N
remains in the control handle (3).
Push the control handle onto the
N
2
handlebar (5) until the holes (6) line
up – the throttle trigger (4) must
point towards the gearbox.
Insert the screw (1) and tighten it
N
down firmly.
4
6
1
5
6
Adjusting and securing the handlebar
A
1
B
Align the handlebar so that
N
distance (A) is about 20 cm (8 in)
and distance (B) about 15 cm (6 in).
Tighten down the screws (1) firmly
N
in a crosswise pattern.
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
FS 56, FS 56 R, FS 56 C, FS 56 RC

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Fs 56rFs 56 cFs 56 rc

Tabla de contenido