Example Of A Program Set-Up - ELNA 683 Manual De Instrucciones

SAFETY 4 THREAD . SAFETY 4 FILS . SEGURIDAD 4 HILOS
DF
1
SL
2.5
CW
N

Example of a Program Set-up

Safety 4 Thread
Model 683 only
Use the recommendations for settings
found in the stitch definitions. See pages
32~36.
Model 686 only
Use the recommendations for the
settings found on the reference card.
NOTE: Machine should not be
threaded before program set-up
occurs. Cut and remove all threads.
HINT: Cut thread at looper and
needle eyes and hand pull thread
away.
IMPORTANT: Never press on foot
control to sew out thread.
IMPORTANT: Always hand turn
flywheel towards you (counter-
clockwise).
Elna recommends reading symbols
from left to right.
1. Adjust differential feed dial to 1.
2. Adjust stitch length dial to 2.5.
3. Set cutting width dial to N.
28