Lubricating The Gearbox; Storing The Machine - Stihl FCS-KM Manual De Instrucciones

English / USA
If you crank the engine in the
START position, the edger blade
may rotate when the engine starts.
For this reason, do not run the unit
for any longer than necessary in the
starting throttle position.
The starting procedure is now as
described in the CombiEngine
instruction manual.
To shut down the engine
: Move the slide control in the
directon of the arrow ( h ) to
STOP – $ or move the stop
switch to $.
16
Lubricating the
Gearbox
1
: Check grease level regularly –
about every 25 hours of operation.
: Unscrew the filler plug (1).
: If no grease can be seen on the
inside of the filler plug, screw the
tube of grease (2) – see "Special
Accessories" – into the filler hole.
: Squeeze up to 1/5 oz (5 g) grease
into the gear housing.
Do not not completely fill the gear
housing with grease.
: Refit the filler plug and tighten it
down firmly.

Storing the Machine

For periods of about 3 months or longer:
: Remove, clean and inspect the
blad.
: If the CombiTool is stored
separately, fit the protective cap on
2
the drive tube to avoid dirt getting
into the coupling.
: Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
FCS-KM