Mounting The Combitool; Fitting The Cutting Blade - Stihl FCS-KM Manual De Instrucciones

English / USA
8
: Line up the gearbox (2) on the drive
tube (8) so that the lug (see arrow)
points vertically upwards when the
depth wheel (7) is vertical.
: Tighten down the clamp screws
firmly.
14

Mounting the CombiTool

2
4
7
: Engage lug (1) on drive tube in
slot (2) in the coupling sleeve and
push home the drive tube as far as
stop.
: When correctly installed, the red
line (3) (arrow point) must be flush
with the end of the coupling sleeve.
: Tighten the wing screw (4) firmly.
Reverse the above sequence to remove
the drive tube.
2
1
3

Fitting the Cutting Blade

1
: Place the power edger on a
suitable support so that the blade
mounting (1) faces upwards.
FCS-KM