Connection; Filling The Bean Container - melitta Caffeo Bistro Manual De Instrucciones

4.2

Connection

• Plug the power cable into an appropriate power socket.
Warning!
Danger of fire and electric shock due to incorrect supply voltage,
incorrect or damaged connections and power cable.
– Ensure that the supply voltage corresponds to the supply voltage specified
on the identification label of the appliance. The identification label is on the
right side of the appliance behind the cover (Fig. B, no. 18).
– Make sure that the power socket meets the applicable standards for
electrical safety. If in doubt, contact a qualified electrician.
– Never use damaged power cables (damaged insulation, bare wires).
– During the guarantee period, have the damaged power cable replaced
only by the manufacturer; only after the guarantee period have it replaced
by qualified specialists.
4.3

Filling the bean container

Thanks to the two-chamber bean container „Bean Select", you can have the choice
between two different types of coffee. For example, you can fill one chamber with
espresso beans and the other with café crème beans. Then you can conveniently
switch between the two types using the tilt lever.
Fill the bean container (Fig. A, no. 8) with fresh coffee beans. Each
•
of the two chambers can be filled with a maximum of 135 g of coffee
beans.
Caution!
– Fill the bean container with coffee beans only.
– Never fill the bean container with ground, freeze-dried, or caramelised
coffee beans.
• Select the desired bean type by setting the tilt lever to the appropriate
chamber.
Heft_Caffeo_Bistro_EU_2.2.indd 51
51
09.04.2014 14:33:51