Waeco MagicSpeed MS800 Instrucciones De Montaje Y De Uso página 52

_MS-800.book Seite 52 Donnerstag, 1. Juni 2006 8:22 08
Safety and installation instructions
Observe the following installation instructions:
Secure the parts of the MagicSpeed system installed in the vehicle in
such a way that they cannot become loose under any circumstances
(sudden braking, accidents) and cause injuries to the occupants of the
vehicle.
Make sure the driver does not have to reach through the steering wheel
to operate it.
To prevent damage, when drilling ensure that there is sufficient space on
the other side for the drill head to come out (2, page 4).
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(1 11, page 3) or a voltmeter (1 12, page 3).
Test lamps with an illuminant (1 18, page 3) take up voltages which are
too high and which can damage the vehicle's electronic system.
When making electrical connections, ensure that
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection ( 3, page 4).
Insulate all connections.
Secure the cables against mechanical wear with cable binders or
insulating tape, for example to existing cables.
Please observe the following instructions in particular:
Observe the applicable legal regulations.
When driving, make sure no other road users can be injured.
MagicSpeed is designed as an additional aid; i.e., it does not relieve you
of the duty of taking due care when driving.
52
MagicSpeed MS800