Waeco MagicSpeed MS800 Instrucciones De Montaje Y De Uso página 75

_MS-800.book Seite 75 Donnerstag, 1. Juni 2006 8:22 08
MagicSpeed MS800
➤ Press the SET button if you are using the blue wire as the signal input, or
➤ ... press the RES button if you are using the yellow wire as the signal
input.
✓ The speed regulator switches on and switches to control mode. In this
mode you adjust the control range.
➤ To save the set PPM values, press the brake.
✓ Each time you change the PPM setting, all previous INIT settings
including the factory default settings are overwritten; the GAIN setting,
however, remains unchanged.
➤ If the speed controller reacts to the speed too slowly or too suddenly, you
must make the INIT setting (see chapter "Setting the sensitivity (INIT
mode )" on page 75).
➤ If the speed regulator works too slowly or too suddenly in control mode,
you must make the GAIN setting manually (see chapter "Setting the
control sensitivity (GAIN mode)" on page 76).
10.5 Setting the sensitivity (INIT mode )
In INIT mode you can set the sensitivity of speed reaction. If the speed
regulator reacts to the speed too slowly you must increase the INIT value. If
it reacts too suddenly to the speed, you must decrease the INIT value.
➤ Start setup mode (chapter "Starting setup mode" on page 73).
➤ To set the sensitivity, apply the brake and hold it down.
➤ With the brake applied, press the RES button three times.
✓ You will hear a low-pitched signal each time you press the button.
➤ Release the brake.
✓ You will hear three high-pitched signals.
Note
If you do not hear three signals, repeat the procedure.
➤ With the speed controller activated, drive at any speed above the
activation speed (40 km/h).
➤ Press the SET button until the speed regulator takes on the speed you are
driving at.
Setting and teaching MagicSpeed
75