Guarantee; Disposal - Waeco MagicSpeed MS800 Instrucciones De Montaje Y De Uso

_MS-800.book Seite 84 Donnerstag, 1. Juni 2006 8:22 08

Guarantee

➤ Check the plug connection to the interface module, make sure the cables
are correctly positioned and pay attention to the colour code of the plug.
➤ Use a voltmeter to test that none of the cables in the wiring harness are
damaged. This is the procedure for each of the three cables:
– Connect a lead of the voltmeters to a cable of the interface module.
– Connect the other lead of the voltmeter to the corresponding cable on
the electronic module.
– Make sure the voltmeter measures throughput.
The speed regulator does not work evenly in control mode
➤ If the speed regulator works too suddenly or the car speeds up too much
in control mode, you must decrease the GAIN value (see chapter "Setting
the control sensitivity (GAIN mode)" on page 76).
➤ If the speed controller operates too slowly in control mode, you must
increase the GAIN value (see chapter "Setting the control sensitivity
(GAIN mode)" on page 76).
15 Guarantee
The statutory warranty period applies. If the product is defective, please
return it to the WAECO location in your country (see the back of the
instruction manual for the address) or to your dealer. For repair and
guarantee processing, please include the following documents when you
send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
16

Disposal

➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the MagicSpeed, ask your local
recycling centre or specialist dealer for details about how to do this
in accordance with the applicable disposal regulations.
84
MagicSpeed MS800