_MS-800.book Seite 78 Donnerstag, 1. Juni 2006 8:22 08
Performing a functional test
✓ You will hear two high-pitched signals.
11
Performing a functional test
Note
The lowest speed at which the speed regulator works is around
40 km/h.
➤ Start the car.
➤ Switch on the speed controller using the ON/OFF button on the control
element.
➤ Drive at a speed of 40 to 50 km/h.
➤ Press the SET button to activate the speed regulator.
✓ The speed controller gently takes on the speed and maintains the driving
speed constantly.
Setting the sensitivity
If the speed regulator does not switch on gently and the speed increases or
decreases during control mode, you can adjust the sensitivity of the speed
controller (see page 72):
If the speed controller takes on the speed you are driving too quickly or
suddenly, you must reduce the INIT value (see chapter "Setting the
sensitivity (INIT mode )" on page 75).
If the speed controller takes on the speed you are driving too slowly, you
must increase the INIT value (see chapter "Setting the sensitivity (INIT
mode )" on page 75).
If the speed regulator works too suddenly or the car speeds up too much,
you must decrease the GAIN value (see chapter "Setting the control
sensitivity (GAIN mode)" on page 76).
If the speed regulator works too slowly or the car slows down too much,
you must increase the GAIN value (see chapter "Setting the control
sensitivity (GAIN mode)" on page 76).
78
MagicSpeed MS800