Waeco MagicSpeed MS800 Instrucciones De Montaje Y De Uso página 60

_MS-800.book Seite 60 Donnerstag, 1. Juni 2006 8:22 08
Connecting MagicSpeed electrically
Green/red, pink/red and blue/red
➤ Lay the three cables from the interface module to the electronic module.
➤ Connect the three cables to the interface module.
Note the colour code on the interface module.
Orange cable
Caution
Make sure the ignition is switched off. Otherwise a fuse may blow.
➤ Connect the orange cable to a connected positive terminal (terminal 15).
➤ Use a voltmeter to check whether the selected positive terminal carries
the full operating voltage (12 V) and that the orange cable carries no
voltage when the ignition is off.
This test is usually done at the fuse box.
Caution
Do not connect the orange cable to the power supply of the
vehicle accessories (ACC).
Green cable
➤ Connect the green cable to an earth point on the car or to the bare metal
earth connection on the bodywork.
The main vehicle earth is usually on the left or right hinge post.
Brown and brown/white cables
➤ Connect the brown cable and the brown/white cable to the brake light
switch (8 1, page 7).
If there are more than two cables coming from the brake light switch, this is
how to identify the two cables you need:
➤ Use a voltmeter to measure the voltage on the cables.
One of the two original cables should have a permanent positive voltage
(terminal 30, 12 V) or a connected positive voltage (terminal 15).
60
MagicSpeed MS800