Assembly; Assembling Engine And Shaft Assembly; Connecting Stop Switch Wires; Connecting Throttle Cable - Maruyama EH230DSL Manual Del Propietário

Assembly

Assembling Engine and
Shaft Assembly
Attach the clutch drum housing to the engine using the
four screws supplied with the unit.

Connecting Stop Switch Wires

Shaft Grip
Stop Switch Wires
Matching Connectors
1. Install the plastic tube (packed with the shaft
assembly) around the throttle cable and stop
switch wires.
2. Loosen the knob and remove the air filter cover to
access the stop switch wires.
Engine
Screw (4)
Clutch Drum Housing
Plastic Tube
Throttle Cable
Air Filter
Cover
Knob
3. Plug the stop switch wires into the matching
connectors from the engine. Note that wire
polarity is not important.

Connecting Throttle Cable

1. With the air filter cover removed, insert the throttle
cable through the cable adjuster sleeve on the
carburetor bracket. Make sure the end of the cable
housing is seated positively in the sleeve.
Stop Switch Wires
Throttle Cable Housing
Carburetor Bracket
Cable Adjuster
Sleeve
2. Position the slotted fitting on the carburetor so the
recessed hole for the lug is away from the cable
adjuster sleeve.
3. Rotate the carburetor throttle cam and slip the
throttle cable through the slot in the slotted
fitting, making sure the cable lug drops into the
recessed hole.
— US-11 —
Cable Adjuster Sleeve
Locknut
Throttle Cable
Recessed Hole
Throttle Stop/Idle Speed
Adjuster Screw Bracket
Carburetor Throttle Cam
Slotted Fitting
Idle Speed
Adjustment Screw
Matching
Connectors
Slotted Fitting
Cable
Lug