Assembly; Assembling Engine And Shaft Assembly; Loop Handle Installation; Connecting Stop Switch Wires - Maruyama B230C Manual Del Propietário

Assembly

Assembling Engine and
Shaft Assembly
Attach the clutch drum housing to the engine using the
four M5 x 20 screws supplied with the unit.
Engine

Loop Handle Installation

Screw (4)
Nut (4)
Loop handle must be assembled gearcase side from
the arrow (A).
1. Slip the rubber sleeve around the shaft assembly.
2. Rotate the rubber sleeve so the split is to one side.
3. Place the loop handle and the bottom clamp over
the rubber sleeve.
Shaft Assembly
M5×20 Screw （4）
Clutch Drum Housing
(A)
Loop Handle
Shaft Assembly
Rubber Sleeve
Bottom Clamp
4. Install the four screws and nuts. Leave the screws
finger-tight.
5. Reposition the loop handle up or down the shaft
assembly to the most comfortable position, but
don't over to the arrow mark.
6. Tighten the screws and nuts.

Connecting Stop Switch Wires

Shaft Grip
Stop Switch Wires
1. Install the plastic tube (packed with the shaft assembly)
around the throttle cable and stop switch wires.
2. Plug the stop switch wires into the matching connectors
from the engine. Note that wire polarity is not
important.
— US-10 —
Plastic Tube
Stop Switch Wires
Throttle Cable
Air Filter Cover
Knob